I used to have a director server along with a T1k and 90. The server is long gone. I'm going to be getting rid of the 90 and T1k soon, but I want to factory reset them first. I'm really struggling with this. I've been able to get into each unit via the management console, but I don't see the option to factory reset. I can change the ip info (ip, mask, gateway) along with server ip, but that's it. The 90 keeps spewing out messages like this:
ERROR: MGCP_SendToNetwork(, 67, <xxx.xxx.xxx.xxx>:2427) errno 65: errno = 0x41
from MGCP_TRANS_ProcessTimeOut 6
I replaced the IP with x's before I posted. This was the IP of an old phone. This message comes up multiple times for all the different phones that used to communicate with it. My biggest question is: if this unit still remembers the old ip addresses, what other information does it still have stored on it?
thanks in advance.
ERROR: MGCP_SendToNetwork(, 67, <xxx.xxx.xxx.xxx>:2427) errno 65: errno = 0x41
from MGCP_TRANS_ProcessTimeOut 6
I replaced the IP with x's before I posted. This was the IP of an old phone. This message comes up multiple times for all the different phones that used to communicate with it. My biggest question is: if this unit still remembers the old ip addresses, what other information does it still have stored on it?
thanks in advance.
